DrRobot Jaguar User's Guide download pdf (Page 15)

www.DrRobot.com

V20.12.14

- 15 -

6) Press button for few seconds, the charge station will check the battery and display what the reading is. It

should be same as your settings above.

7) If everything is right, you can press

button again to start charging.

8) Press

to switch the display to show the battery status. The display

should show each battery reading as below image.

* Note: If any battery reading is missing, please turn off the charging station and turn the Power switch to “OFF”,

and check the 7-pin connector, make sure it is connect well.

9) Keep the charger away from children and pet at all time! Never leave the charger unsupervised when it

is connected to its power supply. For more detail about charger station operation, warning and error message,

maintenance and safety message, please refer to “Intelligent Digital Balance Charger Operating Manual”.

Using DrRobot Jaguar4X4 Motor Control Demo Program

You could install the Jaguar4X4 Motor Control demo program from the CD. After installation, you could run the

WiRobotGateway program from Desktop.

Please input the Robot ID as “DrRobot”. Make sure the IP address is your robot IP (default is “192.168.0.60”)

and the port number is “10001”.

Click the “Connect” button.

Then run the DrRobot Jaguar4X4 Motor Control Demo program.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

No comments

DrRobot Jaguar User's Guide Page 15